Enjoyed This Guide? Add The NewRoof Guys As A Preferred Source On Google To See More Like It.
The short answer: heat tape, more accurately called a roof and gutter de-icing cable, can keep a narrow drain path open through ice at the eaves, but it doesn't fix what causes ice dams, and it's electrical equipment that has to be the right kind and installed the right way. For most Northern Utah homes, the better first step before the snow sticks is finding out why the roof edge is icing up.
The timing matters this week. The National Weather Service office in Salt Lake City said in the area forecast discussion it posted Friday morning (5:52 AM MST, Nov. 13) that "multiple storms will impact the region over the next 7 days." A Monday night through Tuesday night system "looks like this could be a colder system, which will result in lower snow levels, potentially down to at least 5000 feet," and another storm could arrive by Thursday. KUER reported the same day, citing NWS meteorologist Hayden Mahan, that the second and third storms, around Nov. 17 and Nov. 19, may bring the potential for the first snow of the season in the Salt Lake Valley. Forecasts change, so check the latest from the NWS Salt Lake City office before you plan around a date.
Here's what the evidence says about heat tape, and what to check first.
What heat tape on a roof actually does
Roof de-icing cable is a heating cable run in a zigzag along the lower edge of the roof, inside gutters, and down the downspouts. Its job is to keep a channel open so meltwater can drain instead of backing up behind ice.
The manufacturers say plainly what it is not for. Tyco Thermal Controls' design and installation guide for its WinterGard Wet roof and gutter de-icing cable says the cable "is designed to provide a continuous path for melt water, not to clear accumulated snow," and that it "will not keep snow or ice from falling off the roof." That's a product guide, so treat it as the maker's own description of the product's limits, not as an independent test.
A 1979 University of Minnesota Agricultural Extension fact sheet, Preventing Ice-Dams on Minnesota Homes, put the limits more bluntly. It called eave cables a temporary measure and said "the melting effectiveness of such heat tapes is limited to only a few inches from the cable and the sawtooth melting often causes uproof secondary ice-dams to develop. In addition, these electric cables use up a great deal of energy." That publication is decades old, but the physics it describes hasn't changed.
Why heat tape doesn't fix the cause
Ice dams start with heat, not with snow. University of Minnesota Extension's current guide, Dealing with and preventing ice dams (reviewed 2022), explains that warm air leaking from the house into the attic warms the roof deck, melts snow from underneath, and the water refreezes at the colder eave. On air leakage through ceiling penetrations, it says "in many homes this is the major mode of heat transfer that leads to the formation of ice dams."
Its long-term fix comes in a specific order: "First, make the ceiling air tight so no warm, moist air can flow from the house into the attic space." Then, after the air leaks are sealed, "consider increasing the ceiling or roof insulation." A cable at the eave doesn't do either of those things. It manages the symptom at the edge of the roof while the heat that started the melt keeps escaping.
Our earlier guide to Utah ice dams and freeze-thaw damage covers the causes and the warning signs you can check from the ground in more detail.
If you do use de-icing cable, these safety points matter
Some homes have a stubborn trouble spot, such as a low-slope porch tie-in or a north-facing valley over a gutter, where a cable is a reasonable stopgap. If you go that way, the safety record depends on using the right product and installing it correctly.
- Use cable made for roofs and gutters. UL's standard for commercial trace heating, UL 515, points residential "Roof and Gutter De-Icing Cable Units" to a separate investigation, UL 1588. The U.S. Consumer Product Safety Commission's heat tape guidance says: "Do not use heat tapes designed for water pipes on gutters, driveways, or fuel lines." Check the package and the listing mark for roof and gutter de-icing use.
- Ground-fault protection isn't optional. nVent's design guide for its RAYCHEM IceStop roof and gutter system says that "to minimize the danger of fire from sustained electrical arcing if the heating cable is damaged or improperly installed," and to comply with agency certifications and national electrical codes, "ground-fault equipment protection must be used on each heating cable branch circuit. Arcing may not be stopped by conventional circuit protection." CPSC's guidance for heat tapes also says to plug them into a GFCI-protected outlet.
- Inspect it every year. CPSC advises homeowners to inspect heat tapes each year and replace them if they show discolored surfaces (especially at the plug), charring, cuts or breaks in the insulation, or bare wires. Do that check from the ground or at the outlet.
- Follow the cable maker's attachment instructions. How clips attach at the shingles, the drip edge and the gutter matters. Ask the installer how the cable is attached and whether anything penetrates the roof.
- New outlets and circuits are electrical work. If an eave outlet or a dedicated circuit is needed, hire a licensed electrician.
One more safety line: don't get on a ladder or the roof to string cable, chip ice, or clear snow in winter. Winter ladder and roof work on icy surfaces is a fall risk. Have roof-level work done by a crew with proper fall protection.
What Northern Utah homeowners can do this week
You can handle most of this from inside the house or from the ground:
- Look at last winter's photos. A heavy band of ice along one stretch of eave, or icicles above a heated room, points to heat escaping there.
- Check the attic from the hatch. Look for thin or missing insulation, gaps around light fixtures, ducts and the hatch itself, or frost on the underside of the roof deck. If you go in, step only on the framing, never on the insulation.
- Keep gutters and downspouts clear. On single-story homes, ladder work should only happen with a helper holding the ladder. On two-story homes, have it done.
- Don't wait for a leak to find a weak spot. Cracked or lifted shingles at the eave, worn pipe boots, and loose flashing are easier to repair in a dry week than in a storm.
None of this requires buying anything today. It's about knowing which problem you actually have before the colder storms arrive.
Repair, restore, or replace before the snow sticks
When a roof ices up at the edges, the roofing side of the fix usually falls into one of three buckets.
- Repair. Damaged eave shingles, lifted tabs, worn pipe boots and loose flashing get fixed so meltwater has fewer ways in.
- Restore. If the shingles are aging but still sound, GoNano restoration may be an option. The NewRoof Guys are an authorized GoNano installer in Utah. Restoration doesn't fix attic heat loss or ice dams, and rejuvenation isn't right for every roof. We'll tell you if yours isn't a candidate.
- Replace. If the roof has reached the point where repairs don't make sense, replacement is the time to address the eave details from the deck up.
The NewRoof Guys serve homeowners across Utah, with a focus on the Wasatch Front, including Davis and Weber counties. We'll look at the eaves, valleys, gutters and flashing, tell you what we see, and separate what needs attention now from what can wait.
Talk with The NewRoof Guys
If your roof iced up last winter, or you're not sure what you're looking at, Book a free inspection or email us at [email protected]. We'll check the roof and give you a straight answer on whether it needs a repair, a restoration, a replacement, or nothing at all.
Verified fact vs. our interpretation
- Verified (primary sources): the NWS Salt Lake City forecast discussion wording on storms and snow levels (Nov. 13); KUER's report citing NWS meteorologist Hayden Mahan on possible first Salt Lake Valley snow; UMN Extension's explanation of air leakage and its fix order; the 1979 UMN fact sheet's description of heat-tape limits; UL 515's pointer to UL 1588 for residential roof and gutter de-icing cable; CPSC's heat tape safety guidance; nVent's ground-fault protection requirement.
- Manufacturer statements (marketing or product literature): Tyco's description of what WinterGard Wet cable does and does not do; nVent's installation warnings. These describe the makers' own products.
- Interpretation (ours): that for most homes, finding the heat loss comes before buying cable; that cable can be a reasonable stopgap at a specific trouble spot; and that roof-level winter work belongs to a crew with fall protection.
Sources
- National Weather Service Salt Lake City, Area Forecast Discussion, 5:52 AM MST Fri Nov 13, 2026. https://forecast.weather.gov/product.php?site=SLC&issuedby=SLC&product=AFD
- KUER, "October soaked Utah. Now it's November's turn to step in," David Condos, Nov. 13, 2026. https://www.kuer.org/science-environment/2026-11-13/utah-historic-october-rain-november-whats-next
- University of Minnesota Extension, "Dealing with and preventing ice dams" (reviewed 2022). https://extension.umn.edu/garden-and-home/home-maintenance/caring-for-a-home/dealing-with-and-preventing-ice-dams
- University of Minnesota Agricultural Extension Service, "Preventing Ice-Dams on Minnesota Homes," Forestry Fact Sheet No. 12, 1979. https://conservancy.umn.edu/server/api/core/bitstreams/9f82be1c-9cba-42f0-93b6-0c02113fb9fe/content
- UL Standards & Engagement, UL 515 scope (residential roof and gutter de-icing cable units refer to UL 1588). https://www.shopulstandards.com/ProductDetail.aspx?productId=UL515_2_I_20221124
- U.S. Consumer Product Safety Commission, "CPSC Re-Issues Heat Tape Guidelines In Wake Of Zoo Fire" (1996). https://www.cpsc.gov/Newsroom/News-Releases/1996/CPSC-Re-Issues-Heat-Tape-Guidelines-In-Wake-Of-Zoo-Fire
- nVent RAYCHEM, Roof and Gutter De-Icing (IceStop) design guide. https://www.caldetection.com/images/pdf/raychem/design/RAYCHEM-DG-H56070-IceStopRGDI-EN.pdf
- Tyco Thermal Controls, WinterGard Wet Roof & Gutter De-Icing System Design, Installation and Maintenance Guide. https://assets.usesi.com/product-media/catalogs/USESI_348809_catalog.pdf
GoNano is a trademark of its owner.
Frequently asked questions
Does heat tape stop ice dams?
Not by itself. Roof de-icing cable keeps a narrow drain path open through ice at the eave and in gutters. One cable maker's guide says its cable provides "a continuous path for melt water, not to clear accumulated snow." Ice dams start with heat escaping into the attic, so the lasting fix is air sealing and insulation.
Is heat tape on a roof safe?
It can be when it's the right product and installed correctly. Use cable made for roof and gutter de-icing, not pipe heat tape. CPSC says not to use pipe heat tapes on gutters. Manufacturers require ground-fault equipment protection on each heating cable circuit. Inspect it every year for charring, cuts or bare wires.
Should I get on my roof to install heat tape or clear ice?
No. Icy eaves and winter ladders are a fall risk. Do your checks from the ground and the attic hatch, and have roof-level work done by a crew with proper fall protection.
Will Utah get valley snow this month?
The NWS Salt Lake City office forecast multiple storms over the next 7 days as of Nov. 13, with a colder Monday night through Tuesday night system and snow levels potentially down to at least 5,000 feet. KUER, citing an NWS meteorologist, reported the potential for the first Salt Lake Valley snow of the season. Check the latest NWS forecast, since timing changes.
Can roof restoration prevent ice dams?
No. Restoration is about aging but still sound shingles. It doesn't stop heat from escaping into the attic. The NewRoof Guys are an authorized GoNano installer in Utah, and we'll tell you if restoration isn't right for your roof.